Formerly Emhart Teknologies & Infastech

In-Station Verification

STANLEY QPM Cordless tools have a VIRTUAL tether to keep your error-proofing intact.

Control where your STANLEY Cordless tool can be utilized with In-Station Verification. Once “married” to a host controller the tool must stay in a virtual zone created by that same controller to operate. Or re-enter the zone to re-enable the tool after the tool was disabled due to completing a fastener batch count or on time.

You are in control as to where your QPM Cordless tool is used.

There are 3 modes:

  • Check-in on QPM Cordless tool waking up
  • Check-in on Job Reset or Job Select
  • Check-in on Time